Pitman Arm, Flat, No Master Splines, Reamed GM Drag Link Taper @ 5.625", ([email protected]) ZJ Front and Rear Trac Bar

Front and Rear Trac Bar Geometry Correction Bracket

Dana Super 30

Please keep in mind that until you get our nut on there (i

(4) 5/8"-18 x 2-3/4" x 8" round tube U-bolt

Pitman Arm, Flat, No Master Splines, Reamed GM Drag Link Taper @ 5.625", ([email protected]) ZJ Front and Rear Trac BarYou've selected the flat pitman arm reamed to a GM drag link taper 5 5 8" from center of spline hole to center of tapered hole. This is a flat FORGED pitman arm (no drop). It comes tapered from the bottom up for a GM drag link end (example part numbers: ES2026R or ES2027L) at 5 5 8". Typically used with a 6" steering arm (center of ball joint to drag link hole) for lock to lock steering. WARNING: If you're cutting off the excess material, you must